Periodic ripples in suspended graphene

We study the mechanism of wrinkling of suspended graphene, by means of atomistic simulations. We argue that the structural instability under edge compression is the essential physical reason for the formation of periodic ripples in graphene. The ripple wavelength and out-of-plane amplitude are found to obey 1/4-power scaling laws with respect to edge compression. Our results also show that parallel displacement of the clamped boundaries can induce periodic ripples, with oscillation amplitude roughly proportional to the 1/4 power of edge displacement. The results are fundamental to graphene's applications in electronics.Comment: 5 Figure

How Stress Can Reduce Dissipation in Glasses

We propose that stress can decrease the internal friction of amorphous solids, either by increasing the potential barriers of defects, thus reducing their tunneling and thermal activation that produce loss, or by decreasing the coupling between defects and phonons. This stress can be from impurities, atomic bonding constraints, or externally applied stress. Externally applied stress also reduces mechanical loss through dissipation dilution. Our results are consistent with the experiments, and predict that stress could substantially reduce dielectric loss and increase the thermal conductivity.Comment: 9 pages, 7 figure

Mechanical properties of carbynes investigated by ab initio total-energy calculations

As sp carbon chains (carbynes) are relatively rigid molecular objects, can we exploit them as construction elements in nanomechanics? To answer this question, we investigate their remarkable mechanical properties by ab-initio total-energy simulations. In particular, we evaluate their linear response to small longitudinal and bending deformations and their failure limits for longitudinal compression and elongation.Comment: 6 pages, 4 figures, 1 tabl

Pseudomagnetic fields and ballistic transport in a suspended graphene sheet

We study a suspended graphene sheet subject to the electric field of a gate underneath. We compute the elastic deformation of the sheet and the corresponding effective gauge field, which modifies the electronic transport. In a clean system the two-terminal conductance of the sample is reduced below the ballistic limit and is almost totally suppressed at low carrier concentrations in samples under tension. Residual disorder restores a small finite conductivity.Comment: 4 page

Impact of elasticity on the piezoresponse of adjacent ferroelectric domains investigated by scanning force microscopy

As a consequence of elasticity, mechanical deformations of crystals occur on a length scale comparable to their thickness. This is exemplified by applying a homogeneous electric field to a multi-domain ferroelectric crystal: as one domain is expanding the adjacent ones are contracting, leading to clamping at the domain boundaries. The piezomechanically driven surface corrugation of micron-sized domain patterns in thick crystals using large-area top electrodes is thus drastically suppressed, barely accessible by means of piezoresponse force microscopy

Modeling the buckling and delamination of thin films

I study numerically the problem of delamination of a thin film elastically attached to a rigid substrate. A nominally flat elastic thin film is modeled using a two-dimensional triangular mesh. Both compression and bending rigidities are included to simulate compression and bending of the film. The film can buckle (i.e., abandon its flat configuration) when enough compressive strain is applied. The possible buckled configurations of a piece of film with stripe geometry are investigated as a function of the compressive strain. It is found that the stable configuration depends strongly on the applied strain and the Poisson ratio of the film. Next, the film is considered to be attached to a rigid substrate by springs that can break when the detaching force exceeds a threshold value, producing the partial delamination of the film. Delamination is induced by a mismatch of the relaxed configurations of film and substrate. The morphology of the delaminated film can be followed and compared with available experimental results as a function of model parameters. `Telephone-cord', polygonal, and `brain-like' patterns qualitatively similar to experimentally observed configurations are obtained in different parameter regions. The main control parameters that select the different patterns are the mismatch between film and substrate and the degree of in-plane relaxation within the unbuckled regions.Comment: 8 pages, 10 figure